The HR4013C Rotary Hammer from Makita is powered by an 1100 W motor and produces super speed and efficiency during drilling, chiselling and demolition operations in concrete.
The Anti Vibration technology built into this specific model will produce unrivalled lower levels of vibration. This is achieved by using active vibration absorbers, and damper springs absorb the reaction force caused by the drill bit at the moment of impact. The level of vibration is further reduced by completely separating the machine holding section from the motor/transmission section. Therefore, when the machine moves the handle stays still, similar to how a shock absorber works on a motor vehicle.
One of the extra features of the HR4013C is the soft no load function that reduces the vibration of the tool body when idling and accordingly decreases the amount of vibration to the operator’s hands. It also minimises the deflection of the bit tip when you begin to chip.
The SDS-Max drive system, with a drilling capacity of 40 mm will drill just about anything.
The one-touch sliding chuck allows for quick and easy bit changes. Due to rotary hammers being used in rugged applications, Makita has focused on the safety aspects of both the operator and the tool. A torque limiter has been built in to ensure stable torque control that stops the rotation of the drill bit in case it hits against any reinforcing bars, thus preventing possible muscular injuries to the operator or damage to the tool.
This 2-mode rotary hammer with its easy to operate operation mode change lever that is located on the top of the motor housing has four setting options –the lock-on position for continuous chiselling applications; a trigger position for intermittent chiselling applications; a bit angle setting and then of course the rotation with hammering.
A soft rubberised D-grip handle and side handle provides added comfort and greater control, while minimising hand fatigue and pain. It also reduces the level of vibration absorbed by the operator.
The HR4013C has a red LED service light that indicates when to replace the carbon brushes.
The HR2631F with anti vibration control
The HR2631F Rotary Hammer is powered by an 800 W motor and produces speed and efficiency during drilling, chiselling and demolition operations in concrete.
The Anti Vibration technology built into this specific model will produce unrivalled lower levels of vibration. This is achieved by using active vibration absorbers and a damper spring that absorbs the reaction force caused by the drill bit at the moment of impact.
Another great feature on the HR2631F is the rotation reversing system using a brush holder unit. The advantage of this system extends the life of the carbon brush by 2.7 times longer that the existing models, protecting the brush from dust and debris and providing the same speed and torque even in reverse.
The one-touch sliding chuck allows for quick and easy bit changes. This three operation mode rotary hammer with its easy to operate operation mode change lever (located on the top of the gear housing) enables the user to switch between rotation and hammering modes and vice-versa without rotating the chuck. There are 40 different bit-angle settings that are adjustable without a chisel adaptor and then of course the rotation with hammering.
The HR2631F has a LED job light that illuminates your work area.
The Makita HR2631F and HR4013C, with their low level of vibration will make a substantial difference to both user and project alike, enhancing operator comfort and productivity.
Enquiries: www.makita.co.za